-
Features
Medium Liquid, gaseous Pressure type Gauge pressure Pressure unit bar Measuring range 0 bar … 10 bar Process temperature –20 °C … +150 °C Maximum ohmic load RA 4 mA … 20 mA, 2-wire (RA ≤ (L+ – 10 V) / 0.02 A [Ohm])
The variant with field housing and current output 4 mA … 20 mA features test terminals that allow metering of the signal current without having to disconnect the device.the signal current without having to disconnect the device.
0 V … 10 V, 3-wire (RA > 10 kOhm)
0 V … 5 V, 3-wire (RA > 5 kOhm)
Output signal 4 mA … 20 mA, 2-wire EHEDG approval 
-
Mechanics/electronics
Process connection Clamp (DIN 32676) DN 32 Wetted parts Stainless steel 1.4435 Internal transmission fluid Synthetic oil, FDA approved Housing material Stainless steel 1.4571 Connection type M12 round connector x 1, 4-pin Supply voltage 10 V DC … 30 V DC Electrical safety Overvoltage protection: 36 V DC
Short-circuit protection: QA towards M
Reverse polarity protection: L+ to M
Protection class: III
Dielectric strength 500 V DC, NEC Class 02 power supply (low voltage and low current max. 100 VA even in the event of a fault) CE-conformity EMC directive: 2004/108/EC, EN 61326-2-3 Weight sensor Approx. 500 g Seal Without seal Enclosure rating IP67 1) Protection class III MTTF 403 years - 1) Enclosure rating IP per IEC 60529. The enclosure rating classes specified only apply when connected with female connectors that provide the corresponding enclosure rating.
Technical drawings
Dimensional drawing Housing with circular connector M12 x 1, IP67
Dimensional drawing Clamp
Connection type
